科榮股份有限公司
沖頭外直徑(內徑),拉深模和縮口模內直徑測量儀

~URP 100 constists of:
~high resolution optical measuring system
motorized z-stage 400mm for exact positioning of specimen table motorized autofocus for measuring optics
stepper motor controller for 2 axis computer for data acquisition and process control, soft- and hardware installed
Flat Panel Monitor Windows Software for device control, data akquisition and -evaluation
Windows software for punch tolerance model development according drawing

~Measuring functions
Inside diameter of ironing rings and necking dies (for necking dies special adapter necessary)
roundness of inside diameter by measurement of diameter in different azimuths (manual rotation of specimen)
Outside diameter of punches and knockouts (z-position freely choosable) step (automatic motorized measurement)
roundness of outside diameter of punches (by manual rotation) outside contour of punches and comparison with tolerance model

~Technical parameters*
*suitable for all rings with inside land (edge), usually used for beverage can manufacture
*outside diameter range of specimen 110…170mm (ouside diameter is not measured!)
*for necking die and knockout measurement special adapters are necessary
*Inside diameter measuring range: 40 mm … 100 mm**
*outside diameter measuring range: 40 mm … 100 mm**
*Resolution of measuring system: 0,05 µm
*Accuracy inside diameter / roundness: ± 1,5 µm***
*Additionally necessary
*Master rings and master punches***

~Notes
* These parameters apply to the standard device and can be adapted to different diameters.
 
** manual adjustment of diameter by operator, stepless between 40mm and 100mm
 
*** certified master ring for calibration required
 
Technical Specifications subject to change without notice

~Measuring principle
The measuring principle corresponds to the principle of the worldwide proven measuring systems »RINGMASTER« and »PUNCHMASTER«.
The system is calibrated by a reference measurement, using a master ring or master punch.

~Environmental demands
measuring room with constant temperature
no vibrations (otherwise semiactive damping recommended)

~URP是特別為飲料制罐業開發的,沖頭/沖環二合一測量儀器。

產品特點
高解析度光學測量系統
用於樣品台精准定位的400mm電機驅動Z-軸
用於光學測量的電機驅動自動對焦軸
2軸步進電機控制器
用於資料獲取和程序控制的電腦
平板顯示器
Windows軟體,用於設備控制、資料獲取和評估

測量功能
拉深模和縮口模內直徑(縮口模需要特別的連接裝置)
沖環內環圓度(需手動轉動,測量不同方位角下直徑)
沖頭外直徑(任意Z軸位置)
階梯(自動檢測)
沖頭外環圓度(需手動轉動)
外部輪廓及公差模型比較

測量原理
URP100的測量原理,與»RINGMASTER«及»PUNCHMASTER«的原理基本相同。該系統需要基準模具進行校準,即使用基準沖環或基準沖頭。
環境要求
測量室溫恒定
無振動(最好有防震動措施)